Using Foil Drive Gen2 with Full Carbon Boards

Wireless Signal with Full Carbon Boards 

If you own, or looking to purchase, a full carbon board to use with your new Gen II system, please read the following article. 

We have found that using high density foam (provided) pushed into the rails of your board gives you better signal propagation. By doing this, it gives you a better signal link between your motor and your controller. 

The more foam you can stuff in, the better the reception is going to be. 

Note: This will not be needed for all boards, but if you have a full carbon board, we recommend doing this.

Also see here for more information on current connectivity concerns with carbon track boards

To learn how to install the foam into your rails, watch this video below. 

Here is a video from Dom giving some practical demonstrations with a range of Armstrong Boards that feature full carbon construction as well as full carbon foil tracks.

As always, if you have any questions, please do not hesitate to reach out to us at support@foildrive.com 

Happy Foil Driving!