The biggest change in the 2027 Duotone Foil Assist is the new HT (High Torque) motor. It powers the two new HT D/LAB sets, and it is also offered as an upgrade for the existing masts.
Duotone have published proper numbers for both motors this time, so we can put them side by side. I've also had the HT motor out on the water myself. Below: what the HT motor changes, how it actually rides, who it is for, and why the new 3-blade propeller matters just as much.
Duotone's own comparison: standard motor against HT motor.
|
5.8Nm
HT torque (vs 4.3)
|
36kg
HT peak thrust (vs 32)
|
37km/h
HT top speed (vs 32)
|
1 gear
Lower for the same speed, in my test
|
The numbers
| Standard Motor | HT Motor | |
| Torque | 4.3Nm | 5.8Nm |
| Max thrust | 32kg | 36kg (+12.5%) |
| KV rating (rpm per volt) | 80KV | 75KV (different winding) |
| Top speed | 32km/h | 37km/h (+16%) |
| Length | 6cm | 7cm |
| Propeller | 2- or 3-blade | 3-blade recommended |
| Feel | Smooth, linear power | More aggressive, more low-end thrust |
From Duotone's 2027 Foil Assist product presentation. Item numbers: Motor 40260-6203, HT Motor 40270-6216.
What the extra torque actually does
Thrust across the remote's speed levels — the HT motor pulls ahead the whole way up.
Torque is what gets you going. The extra low-speed torque is the part of the HT motor you feel most, because the hardest moment on a foil assist is the take-off: getting a board and a rider up out of the water and onto the foil.
That's why Duotone pitch it at two kinds of rider. Heavier riders, where the HT sets are recommended above 85kg, and riders who want to go smaller. More torque at low speed means you can get going on a smaller foil and a lower-volume board.
![]() |
![]() |
The HT Motor & Bell is meant to be paired with the 10Ah batteries.
Duotone recommend running the HT motor with the 10Ah batteries, and say the pairing gives higher torque and stronger acceleration.
On the water with the HT motor: my first-hand test
I'm 76kg, so under the 85kg Duotone aim the HT sets at, but I wanted to know what it does for a lighter rider too. I rode it with the 10Ah batteries, an 800cm² Crest and the SLS 3-blade propeller, in surf.
More top end in reserve. I was consistently about one gear lower than on the standard motor. I'd cruise around at full speed in gear 5, with gear 6, and even gear 7, still there for chasing a bigger, faster wave. Knowing that extra speed is there is really nice in bigger waves, and it means I can drop to a smaller foil like the 675 Crest and still keep up with waves that run faster.
It's modular. The HT motor fits any existing Foil Assist or Cruise mast, and an HT mast can take the standard motor. The motor body is slightly longer and heavier, and it needs its own matching HT bell, but the fittings at the propeller end and the mast end are identical. Your existing 3-blade propellers move straight over.
Motor pod height matters. The current Assist mast puts the motor 17cm below the top plate; the new Assist HT D/LAB mast drops it to 21cm. On my first session the tide was high and the water smooth between waves, and I didn't miss the lower pod. Later, with the tide dropping and the sandbars kicking up more current, I really wanted it. If your spot gets choppy, go for the lower pod.
Speed or runtime? For a lighter rider, the HT motor is about speed. Because it draws more power, my theory is that the standard motor with the 10Ah batteries will give a slightly longer run time. I haven't tested that yet, and I'll update this post when I have.
The 3-blade propeller
Propeller options: the 3-blade comes with every 2027 set; the 2-blade was standard on 2026 sets.
Every 2027 set now comes with a 3-blade propeller instead of the 2-blade. It's made from reinforced plastic, fits both motors and needs the 3-blade hub. Duotone list stronger low-speed thrust, more torque at low revs, better acceleration on take-off and better recovery when the prop breaches the surface.
What I found: I rode the new plastic 3-blade straight after a session on the metal SLS 3-blade. The plastic one was a little less powerful, and I was running about one gear higher, but it wasn't far off. Compared with the old plastic 2-blade, it's night and day. At my weight the 2-blade was only just usable, and for most riders over about 80kg it really wasn't. With the 3-blade in every set, the kit is properly usable straight out of the box.
The 3-blade gives more speed and torque and lets you ride smaller foils, which suits heavier riders. The trade-off is that it's a bit twitchier when the prop breaches the surface, especially with the higher 17cm pod. I notice that more coming from Foil Drive, where my motor sat at around 20cm. Once you're used to it, the extra thrust is worth it.
The blades fold, like the 2-blade. On the Cruise sets you can fit a fixed hub cap that stops them folding, for full-time power. There's also the metal 3-blade SLS upgrade, and because you'll already have the 3-blade hub, you only need to buy the three blades, not a whole new hub.
Already own a Foil Assist? Duotone are sending registered owners a free 3-blade propeller and hub. Register by 21 November.
Which sets have which motor
HT motor on the two D/LAB HT sets; standard motor on the D/LAB 2.0 and aluminium sets.
HT motor: Foil Assist HT Set D/LAB (motor 21cm below the top plate, for surf and downwind) and Foil Cruise HT Set D/LAB (15cm, for flatwater and swell).
Standard motor: Foil Assist Set D/LAB 2.0, Foil Assist Set AL 2.0 and Foil Cruise Set AL 2.0.
Every set gets the 3-blade prop and the 10Ah batteries. The full rundown is in our Foil Assist 2027 overview.
💡 Sam's Tip
If you're under about 85kg, the standard motor with the 3-blade prop is plenty to get you going, and probably gives the longest run time. I'm 76kg and I still loved the HT for the extra top speed on bigger waves. If you're heavier, or you want to drop a foil size and ride a smaller board, that's where the HT motor earns its money. Give us your weight and your setup and we'll tell you which side of the line you're on.
Duotone Foil Assist HT sets
Talk to us about the HT sets, or about upgrading the Foil Assist you already have.
Shop Foil Assist Sets Email Us Your Setup


